How To Attach A Wooden Awning To A House

You want to make sure that it can be fully extended.

How to attach a wooden awning to a house.

They don t require you to build a permanent structure on the deck. Make sure the hardware you use is tight and that your awning does not wiggle around. Determine what type of material you will want to use for your patio awning. Attach the hardware through the brackets and over the awning bar to hold it in place.

This is a huge benefit of hiring an awning company to create and install your awning. They are in essence oversized swatches of water resistant fabric connected to a frame and attached to your house or some other structure. In other words it can be custom fit for the amount of covering you seek. Temporarily nail or brace the ledger in place positioned and leveled at the desired height.

Find a good spot. Lift the awning into place and bolt it to the brackets. Temporarily affix the fabric to the brackets and use this as a reference to identify exactly where any additional supports will be. Attach mounting brackets to your home and verify they are straight with a level.

You don t have to take them down no storage hassles. How to attach a patio awning to your house. Fasten the awning bar to the brackets. Be sure to follow manufacturer instructions.

They are made out of vinyl canvas or solution dyed acrylic. Awnings need approximately 6 to 12 inches of open heightwise wall or roof space to be installed. Pop a caulk line to mark the position for the support brackets. Attach the brackets to the house even with the chalk line making sure they are plumb.

Depending on your brand of awning you will use either a large bolt or a screw to attach the awning into the brackets. Lag bolts or coarse threaded wood screws are usually specified for the installation but each awning is different. Retractable awnings provide instant shade or quickly roll up when you don t need them. Attach vertical screens to the extended awning to block the sun when its low in the sky.

If it is impossible to attach the ledger to a floor joist then fasten the ledger to wall studs which are generally located on 16 inch or sometimes 24 inch centers and doubled up around doors windows and other openings. Wall space needed for attaching. Mark the location of the awning on the side of the house making sure it is level. Make sure that you have an appropriate place for your patio awning.